Electrician in Tbilisi › Services › Electrician on call
Electrical repair in Tbilisi
Power cutting out, lights flickering, a warm circuit? Labex finds exactly where the fault sits and fixes the cause, not just the symptom.
- Board diagnostics and restoration
- Locating and replacing damaged cable
- Breaker and relay servicing
- Earthing and protection checks
- Appliance circuit repair
What signs say the wiring needs checking?
The breaker trips often, lights flicker or dim, a socket or switch warms up, a spark shows at a switch, the power goes in one room only, or there is a smell of burning. The last two are urgent.
How does Labex find the fault?
- Checking the board and separating the circuits
- Taking the load off and measuring the run, one section at a time
- Locating the damaged point before any wall is opened
- Repairing or replacing the section, then re-testing the protection
When one particular socket, switch or light has failed, Labex handles it as a separate job: electrical fault finding and repair. On old aluminium wires, rewiring is often the better answer than a repair.
What does electrical repair from Labex include?
Power cutting out, lights flickering, a warm circuit? Labex finds exactly where the fault sits and fixes the cause, not just the symptom.
How quickly does the electrician arrive?
Labex takes emergency calls first and handles most requests in Tbilisi the same day. Average response time is 30 minutes.
Where does Labex work?
Labex works across Tbilisi, in every district, and in the areas just outside the city.
Can just one room be repaired?
Yes, if the fault really sits on one circuit. Labex checks where the problem ends first, because a one-room symptom often means the whole run is damaged.
Does the wall always have to be opened?
No. The circuit is traced and the fault located first, and the wall is opened only at the point where it is needed.
Should old aluminium wiring be replaced?
If the run heats up, the contacts weaken or the load has grown, replacement is the right call. Labex measures first and then tells you whether the whole run or a section is needed.
What causes a short circuit?
A short circuit is most often caused by damaged insulation, a loose contact, water reaching a point or a faulty appliance, and the breaker trips at once. Labex finds which circuit and which point the short is on and replaces the damaged part.
Why are my lights flickering?
Three things make a light flicker: the bulb or its driver, a loose contact in the switch or the lamp holder, or a voltage drop on the circuit. If several lights flicker together, the cause is on the circuit and an electrician should check it.